Removing
1. Disconnect the wire "masses" from the battery. For more information refer to Specification.
2. Pump out a working liquid from a tank of the amplifier of a steering.
3. Remove the power steering fluid reservoir from the bracket.
4.
CAUTION: Before you start to disconnect or dismantle parts, make sure that the area around the contact surfaces is clean. Plug all open connections to avoid contamination of the system.
NOTE: During this operation, some hydraulic fluid will inevitably spill.
Remove the power steering fluid reservoir.
- Lay down an absorbent cloth to soak up spilled liquid.
- Open the clamps and disconnect the hoses.
Installation
1. Reinstall the parts in reverse order.
2. Fill the power steering system with fluid and bleed air from the system. For more information, refer to Filling and Bleeding the Power Steering System.
Comments on this article