Contents: Power steering working fluid ⇩ Filling volume ⇩ General specification ⇩ Tightening torque specifications ⇩
Power steering working fluid
| Name | Specification |
| Recommended Power Steering Fluid | Texaco Cold Climate Fluid 14315 |
Filling volume
| Name | Filling volume |
| System filling volume - Maximum - Filling up to the mark on the tank | 0.89 l (1.5 pints) (0.9 US quart) |
General specification
| Name | Specification |
| Type | Rack and pinion steering with hydraulic booster, variable hydraulic response proportional to speed, with belt-driven pump, remote working fluid reservoir and working fluid cooler |
| Steering wheel diameter | 395 mm (15,5 in) |
| The number of revolutions from one extreme position to the other | 3,32 |
| Turning circle | 11,45 m (37,5 ft) |
| Gear ratio | 17,8:1 |
| Working pressure of the system | 110 bar (11000 kPa)(1595 lbf/in²) |
| Working pressure of the pump safety valve | 114±4 bar (11400±400 kPa) (1653±58 lbf/in²) |
| The flow rate of the working fluid is constant. | 8.8±0.5 L/min (15.4±0.8 pints/min) (9.2±0.5 US qts/min) |
| Steering rack travel | 166 mm (6,22 in) |
| Piston diameter | 52 mm (1,9 in) |
| Rack diameter | 30 mm (1,12 in) |
| Steering wheel angle sensor brand/part number | Panasonic ECS64SUKX |
Tightening torque specifications
| Description | Nm | lb-ft |
| Power Steering Pump Bolts - All Engines | 25 | 18 |
| High pressure line to power steering pump - all engines | 25 | 18 |
| Power Steering Pump Bolts - All Engines | 25 | 18 |
| High pressure line to power steering pump - all engines | 25 | 18 |
| Low pressure line to power steering pump - all engines | 25 | 18 |
| Steering Wheel Angle Sensor Head Screws | 3 | 2 |
| * Steering column intermediate shaft nut | 22 | 16 |
| ++ Bolt for fastening the intermediate shaft of the steering column to the lower shaft. | 25 | 18 |
| Horn Nut | 10 | 7 |
| Expansion tank mounting bolts | 10 | 7 |
| Air conditioning condenser refrigerant line mounting bolts | 25 | 18 |
| |++ Bolt for fastening power steering lines - 2.7 l | 25 | 18 |
| + Bolts for fastening the power steering mechanism to the crossmember | 175 | 129 |
| High pressure line mounting bolt to steering gear | 25 | 18 |
| Power Steering Line Support Bracket Bolt | 10 | 7 |
| High pressure line nipple nut | 30 | 22 |
| * Tie rod end ball joint nuts | 76 | 56 |
| ** Bolt for fastening the universal joint to the steering gear | 25 | 18 |
| Radiator Access Panel Bolts | 10 | 7 |
| Oil filter | 18 | 13 |
* New nut(s) must be installed
+ New nuts with steel spring clips must be installed
** A new "Patchlock" type bolt must be installed (with a "patch" of thread adhesive)
++ A new bolt needs to be installed
(Data taken from the website: LRman.ru)
Comments on this article