Removing
1. Disconnect the wire "masses" from the battery. For more information, refer to Specification
2. Remove the air filter assembly. For more information refer to Air Filter (19.10.01)
3. Remove the cooling fan shroud.
- Disconnect the coolant hose.
- Release 3 clips.
4.
CAUTION: Before disconnecting or dismantling parts, make sure that the area around the contact surfaces and connections is clean. Plug all open connections to avoid contamination of the system.
NOTE: Some fluid will inevitably spill during this operation.
Remove the power steering reservoir.
- Place a container to catch spilled liquid.
- Release 2 clips.
- Disconnect 2 hoses.
Installation
1. Install the power steering fluid reservoir.
- Clean the contact surfaces of the parts.
- Connect hoses.
- Secure with two clips.
2. Install the cooling fan shroud. Attach the coolant hose.
3. Install the air filter assembly. For more information refer to Air Filter (19.10.01)
4. Fill the power steering system with fluid and bleed air from the system. For more information, refer to Filling and Bleeding the Power Steering System.
Comments on this article