Contents: Dismantling ⇩ Installation ⇩
Dismantling
1. Check that the ignition is off.
2. Unscrew 2 nuts and release the gas pedal with the throttle position sensor from the studs.
3. Disconnect the connector from the throttle position sensor.
4. Remove the gas pedal with the throttle position sensor.
Installation
1. Install the gas pedal with the sensor and connect the connector.
2. Install the gas pedal with the sensor on the studs and tighten the nuts to a torque of 25 Nm.
See the source on the website LRMAN.RU
Comments on this article