After stopping the engine, wait at least one minute before making any repairs to the fuel injection system.
Avoid open flames, sparks or flammable substances.
Prepare to collect spilled fuel.
Removing
1. Disconnect the battery ground wire. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
2. Remove the engine cover. Refer to Procedure: Engine Cover - 2.2L Duratorq - Td4 (501-05 Interior trim, Removal and installation).
3.
4. Tightening torque: 9 Nm
5.
Check that there is no tension in the fuel lines and wiring harnesses. Make sure the fuel pressure is released to zero and the fuel temperature drops to outside temperature.
Prepare to collect spilled fuel. Plug all openings. Use new plugs. Observe absolute cleanliness when handling this element.
6. Tightening torque: 9 Nm
7.
Installation
1. Replace the elements in reverse order.
2. Remove air from the fuel system. Refer to Procedure: Bleeding the Fuel System - 2.2L Duratorq - Td4 (310-00 Fuel supply system - General information, General procedures).
Comments on this article