Rear drum brake pads (Range Rover 3)

Dismantling

1. Raise the rear of the vehicle.

CAUTION: Do not work under a vehicle supported solely by a jack or lift. Always support the vehicle with safety stands.

2. Remove the rear wheels.

3. Remove the brake disc.

BRAKE SYSTEM, REPAIR WORK, Brake disc - rear brake mechanisms.

4. Remove the upper parking brake shoe tension spring.

5. Rotate the brake shoe retainers 90° and remove the brake shoe assembly.

6. Remove the parking brake shoes assembly with the lower tension spring and adjusting ring.

7. Disconnect the lower tension spring and adjusting ring from the brake shoes.

8. Remove the expansion bar.

9. Repeat the operation for the wheel on the other side.

Assembly

1. Clean the rear brake support and brake disc with brake cleaner.

2. Clean the brake release plate.

3. Clean the adjusting ring, lubricate the threads with grease and set the minimum distance between the pads.

FILLING CAPACITIES, USED OPERATING LIQUIDS, OILS AND SEALANTS, Lubrication system.

4. Install the expansion bar.

5. Assemble the pads with the adjusting ring and the lower tension spring.

6. Install the brake pads in place, secure the brake pad retainers and the upper tension spring.

7. Install the brake disc.

BRAKE SYSTEM, REPAIR WORK, Brake disc - rear brake mechanisms.

8. Repeat the operation for the wheel on the other side.

9. Reinstall the rear wheels and tighten the nuts to a torque of 140 Nm.

10. Adjust the parking brake.