Note: The parking brake is installed in the transmission (does not affect the rear wheels of the car, as in most cases). Therefore, when hanging a wheel, place blocking shoes that remain on the ground under the wheels.
1. Loosen the five wheel nuts.
2. Hang up the wheel to be replaced and place a stand under the frame.
3. Loosen the nuts and carefully remove the wheel from the studs.
4. Check the condition of the wheel mounting studs.
5. Alloy wheels: Apply a light coat of anti-seize compound to the mating surface of the wheel to minimize adhesion between the wheel and hub metals.
6. Carefully place the wheel onto the hub. Do not lubricate the studs.
7. Screw on the mounting nuts and tighten them by hand.
8. With the wheel raised, tighten the nuts with a wrench in the order shown in the figure.
9. Lower the vehicle. Finally tighten the wheel nuts to a torque of 130 Nm.
Comments on this article