Contents: Removal ⇩ Installation ⇩
Removal
NOTE: This procedure replaces the side member section along with the rear panel and rear cross member.
1. Disconnect both cables from the battery. For more information, refer to Specification.
2. Remove the rear panel. For more information, refer to Rear Panel (77.80.20)
3. Remove the rear crossmember. For more information, refer to Rear Crossmember.
4.
| Item name | Description |
| 1 | 2 plug welds. (see also figure E55932) |
| 2 | 2 plug welds. |
| 3 | Butt weld. |
5.
| Item name | Description |
| 1 | Butt weld. |
| 2 | 2 plug welds. |
| 3 | 4 plug welds. |
4. Additional information:
- Weld. For more information, see Body Repairs.
- Anti-corrosion protection. For more information, see Anti-corrosion protection.
- Tolerances: For more information, see Body and Frame.
Installation
1. Installation should be carried out in the reverse order of dismantling.
Comments on this article