Engine Control Module 2.7L (Discovery 3)

Removal

1. Disconnect the ground cable from the battery. For more information, refer to Specification.

2. Remove the all-wheel drive control module. For more information, refer to Four-Wheel Drive (4WD) Control Module (41.30.01)

3.

NOTE: A car with a right-hand steering wheel arrangement is shown, while a car with a left-hand steering wheel arrangement is performed in reverse order.

Disconnect the 3 engine wire harness electrical connectors in the order shown. Move the 3 engine wire harness electrical connectors aside for easy access.

4. Remove the ECM mounting plate. Remove the 4 ECM mounting bolts.

5. Remove the ECM. Remove the ECM upper cover.

[The original article is located on: LRMAN.RU]

Installation

1. Install the ECM. Install the ECM upper cover.

2. Install the ECM mounting plate. Install and tighten the 4 ECM mounting bolts.

3. Connect the 3 electrical connectors of the engine wire harness.

4. Install the all-wheel drive control module. For more information, refer to Four-Wheel Drive (4WD) Control Module (41.30.01)

5. Connect the ground cable to the battery. For more information, refer to Specification.

6.