Dismantling
1. Open the sunroof.
2. Remove the tabs covering the glass cover screws.
3. Remove the 6 screws securing the glass cover.
4. Remove the glass cover.
Installation
1. Install the glass cover, tighten the screws for its fastening, but do not completely tighten them yet.
2. Align the glass cover with the roof and tighten the screws. The distance from the control points located on the sides of the hatch to the center line should be 300 mm.
3. Align the front of the glass cover. It should be located 1.0 mm below the roof panel.
4. Align the back of the glass cover. It should be located 1.0 mm above the roof panel.
5. Install the covers covering the screws.
6. Check the operation of the hatch and the correct installation of the glass cover.
7. Close sunroof.
Comments on this article