Module (ECU) — volume control — 5-door models — models with sunroof (Freelander 1)

Dismantling

1. Remove the front and rear door seals.

2. Remove the upper A-pillar covers.

INTERIOR TRIM PARTS, REPAIR WORK, Replacement of the upper decorative panel of the front "A" pillar.

3. Remove the screw covers and unscrew the 6 screws from the front and both rear handrails and remove the handrails.



4. Remove the handrail caps.



5. Loosen and remove the decorative cover of the hatch.



6. Remove both sun visors.

INTERIOR TRIM DETAILS, REPAIR WORK, Sun visor.

7. Unscrew the stud securing the front edge of the roof trim.



8. Models before 04MY: Remove the front dome light lens.

9. Models prior to 04MY: Remove the 2 Torx screws securing the front courtesy light to the body.

10. Models up to 04MY: Remove the lamp from the roof trim, disconnect the connector and remove the lamp.



11. Models from 04MY: Working from the front edge of the lamp, remove the lamp from the roof lining, disconnect the connector and remove the lamp.





12. Unscrew the 2 studs securing the central part of the roof trim.



13. Remove the 8 fasteners securing both upper B/C pillar trims and separate the trims from the headliner.

14. Carefully lower the roof lining to provide access to the volume sensor.



15. Disconnect the connector from the volume sensor.

16. Unscrew the 2 screws securing the interior volume control sensor and remove the sensor.

Installation

1. Install the interior volume control sensor and secure it using screws.

2. Connect the connector to the sensor.

3. Secure the roof lining using pins.

4. Install the upper trim of the "B/C" pillar and secure it with the clamps.

5. Install sun visors.

INTERIOR TRIM DETAILS, REPAIR WORK, Sun visor.

6. Install the upper A-pillar pads.

INTERIOR TRIM PARTS, REPAIR WORK, Replacement of the upper decorative panel of the front "A" pillar.

7. Install the handrails, tighten the screws and install the screw covers.

8. Install the handrail caps.

9. Models before 04MY: Position the front light in place and attach the connector.

10. Models up to 04MY: Install the Torx screws securing the ceiling light and tighten to 6 Nm.

11. Models before 04MY: Install the front dome light lens.

12. Models from 04MY: Position the front light in place and attach the connector.

13. Models from 04MY: Install and secure the front courtesy light into the roof trim.

14. Position and secure the hatch trim.

15. Secure the front and rear door seals.

[The article was copied from a resource: www.LRman.ru]