Sizes of gaps and profiles (Freelander 2)

The following information is intended to guide technical personnel in the installation of exterior panels and decorative body parts. Its purpose is to ensure correct joining of the elements and an acceptable appearance of the vehicle.

NOTE: All dimensions are in millimeters (mm).

Section	Description	Gap	Profile
A-A	Gap between the hood and the bumper trim	5.0 +2.0 -0.0	Not applicable
B-B	Gap between front bumper trim and headlight	5.0 ±2.5 (max cone 2.0)	Not applicable
C-C	Gap between hood and headlight	5.0 +2.0 -0.0	Not applicable
D-D	Headlight relative to bumper trim	4.0 ±2.0	Not applicable
E-E	Between the wing and the headlight	3.0 ±1.0	1.0 ±1.5
F-F	Between the wing and the bumper trim	2.0 +1.0 -0.0	1.5 ±1.0
G-G		5.0 ±1.7	Not applicable

Section	Description	Gap	Profile
H-H	Wing relative to front door	5.0 ±1.0	0.7 ±1.0
J-J	Front door relative to A-pillar	4.5 ±1.0	-2.5 ±1.2
K-K	Front door to door trim	0.0 +1.0 -0.0	-2.0 ±1.0
L-L	Front door relative to rear door	5.0 ±1.0	0.8 ±1.0
M-M	Front door relative to rear door	5.0 ±1.0	1.0 ±1.0

Section	Description	Gap	Profile
N-N	Rear door to door trim	0.0 +1.0 -0.0	-2.0 ±1.0
O-O	Rear door to side panel	4.5 ±1.0	-2.5 ±1.2
P-P	Rear door to side panel	4.5 ±1.0	1.0 ±1.0
Q-Q	Rear door to side panel	5.0 ±1.0	0.5 ±0.5
R-R	Side panel to bumper trim	2.0 +1.0 -0.0	1.5 ±1.0
S-S	Side panel to rear light	3.0 ±1.5	1.0 ±1.2

Section	Description	Gap	Profile
T-T	Rear light relative to bumper trim	3.0 ±2.0	Not applicable
U-U	Rear light relative to the tailgate	5.0 ±1.5	3.0 ±1.3
V-V	D-pillar trim panel relative to tailgate glass	5.0 ±2.0	2.5 ±1.3
W-W	Side panel relative to the tailgate	5.0 ±1.5	2.0 ±1.5
X-X	Luggage compartment door relative to bumper trim	6.0 ±2.7	Not applicable

(The original was published on the portal lrman.ru)