Contents: Removal ⇩ Installation ⇩
Special tool
 303-D121 Puller, General Purpose |
NOTE: The removal procedure description may contain installation steps.
Removal
1.
- Release the lid.
- Loosen, but do not remove, the nut.
- Using the special tool, release the rear wiper arm. Special tool: 303-D121
CAUTION: These components must be installed in the original positions marked during removal.
2. Loosen the rear wiper arm nut. Tightening torque: 7 Nm
3. Remove the rear wiper arm.
4. Remove the rear wiper blade.
NOTE: Do not perform further disassembly if the component is removed only for access.
[The source of the article is located on the website lrman.ru]
Installation
1. When installing, perform the removal procedure in reverse order.
CAUTION: Be sure to align the element with the alignment mark.
Comments on this article