English
Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar
Main
Freelander
Discovery
Range Rover
Defender
Contacts
Articles
Rear window molding
(Discovery 3)
Main
Discovery
Discovery 3
Body and coating
Interior and body trim
Rear window molding
0
Removing
1. Open the tailgate.
2. Remove the bottom quarter of a fringing of back glass.
Release 4 clips.
Loosen the dowel pin.
Installation
1. Establish the bottom quarter of an edging of back glass.
Install the dowel pin.
Lock the clamps.
This article is available at
russian
,
bulgarian
,
belarusian
,
ukrainian
,
serbian
,
croatian
,
romanian
,
polish
,
slovak
,
hungarian
Previous articles
Trim specification
B-pillar upper trim panel
C-pillar upper trim panel
Engine cover 2.7L
Engine cover 4.0L
Engine cover 4.4L
B-pillar lower trim panel
C-pillar lower trim panel
Removal and installation of a covering of a ceiling
Trim panel of the rear side of the body
Rear door trim panel
Rear luggage compartment door trim panel
Front door trim panel
Front door trim panel
Trim panel of the raised luggage compartment door
Door sill trim panel
D-pillar trim panel
A-pillar trim panel
Current article
Rear window molding
Next articles
Rear side panel molding
Left A-pillar molding
Front fender trim
Radiator grille
Similar articles from Land Rover repair manuals:
• Side molding rear window 5-door car
Freelander 1 (1997-2006)
• Rear side panel molding
Freelander 2 (2006-2014)
• Heated rear window relay
Range Rover 3 (2001-2012)
• Power window lifter and rear door window motor
Defender 2007+ (2007-2016)
Comments on this article
No comments yet
How much will 29 + 14 =
Discovery 3
General information
Using the manual
Precautionary measures
Service Information
Technique
Health protection
Road test
Identification codes
Jacking and lifting
Maintenance - diesel
Maintenance - petrol
Chassis
Suspension
Front suspension
Rear suspension
Wheels and tires
Dynamic suspension
Cardan shaft
Rear drive axle
Front drive axle
Front axle axles
Rear axle axles
Brake system
Parking brake
Hydraulic brake
Vacuum brake booster
Anti-lock braking system
Steering
Steering column
Power unit
Petrol engine 4.0L
Petrol engine 4.4L
Diesel engine 2.7L
Engine cooling
Fuel supply
Drive units
Launch system
Ignition system
Emission reduction
Air filtration
Fuel vapor control
Electronic control part
Car gearbox
Clutch
All-wheel drive systems
Transfer case
Exhaust system
Fuel tank and lines
Acceleration control
Electrical equipment
Climate control
Instruments and control lamps
Battery and charging system
Information system
Lighting and headlights
Power distribution
Electronic Function Group
Body and coating
Body elements
Interior and body trim
Mirrors and glasses
Seats
Instrument panel and console
Handles and locks
Windshield wipers and washers
Sunroof and bumpers
Safety system
Body repairs
Repair of front end elements
Repair of back elements
Side panel repair
Frame and body mount
LRman.ru © 2013-2024
|
Mobile version
|
Free Lander
|
Discovery
|
Range Rover
|
Defender
|
Contacts
|
Sitemap
|
Car repair and service instructions Land Rover: Freelander, Discovery, Range Rover, Defender
Comments on this article