Removing
1. Remove headlight assembly. For more information refer to headlight assembly (86.40.49)
2.
WARNING: It is forbidden to carry out work on a vehicle supported only by a jack. Always place secure supports under the vehicle.
Raise the car and place it on stands.
3. Remove the mudguard. Remove 3 fixing screws.
4. Remove 4 clips.
5. Remove the wing molding.
- Remove 2 screws.
- Carefully release the 10 clips.
6.
NOTE: Do not proceed with further disassembly if the part is being removed only for access.
Release the molding from the clips.
Installation
1. Replace the elements in reverse order.
2. Install the headlight assembly. For more information refer to Headlight assembly (86.40.49)
Comments on this article