NOTE: This sensor is only installed on vehicles with xenon headlights, on the left side of the vehicle.
NOTE: The description of the removal procedure may contain a description of the installation steps.
Removing
1. Raise and support the vehicle.
WARNING: Place secure stands under the vehicle.
2. Remove the wheel. Refer to procedure: Wheel and tire (204-04 Wheels and tires, Removal and installation).
3. Tightening torque: 10 Nm
4.
Installation
1. When installing, follow the removal procedure in reverse order.
2. Calibrate the sensor using diagnostic equipment prescribed by Land Rover.
Comments on this article