Suspension height sensor (Discovery 3)

Removal

NOTE: The right rear sensor has a black lever arm and the left rear sensor has a white lever arm.

1.

CAUTION: Never work on a vehicle supported solely by a jack. Always support the vehicle securely.

Raise and support the vehicle.

2. Remove the wheel and tire assembly.

3.

CAUTION: Do not use excessive force to disconnect the height sensor connector.

The article was copied from a resource (LRMAN.RU)
Remove the suspension height sensor.

• Disconnect the height sensor connector.
• Disconnect the electrical connector.
• Remove 2 Torx head screws.

Installation

1. Install the elements in place in reverse order. Tighten the screws. (tightening torque 2.2 Nm).

2.

CAUTION: Calibration of the suspension height using T4 is mandatory in case of dismantling the suspension height sensor drive.

Use T4 to calibrate the suspension system.