Contents: Removal ⇩ Installation ⇩
Removal
NOTE: The removal procedure descriptions in this manual may contain installation steps.
1. Raise and support the vehicle.
WARNING: Ensure that the vehicle is supported securely.
2. Disconnect both rear struts from the stabilizer. Tightening torque: 60 Nm
Do not allow the ball joint to rotate. Discard the nuts.
3. Remove the stabilizer bar bushings. Refer to the procedure: Rear Stabilizer Bar Bushing (204-02 Rear Suspension, Removal and Installation).
The original text was published on the website: www.LRman.ru
4. Remove the stabilizer.
Installation
1. Install the elements back in place in reverse order.
Comments on this article