Rear lower control arm (Freelander 2)

Removal

NOTE: The removal procedure descriptions in this manual may contain installation steps.

1. Raise and support the vehicle.

WARNING: Never work on a vehicle supported only by a jack. Always support the vehicle securely.

2. Remove the wheel and tire assembly. Refer to procedure: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3. During installation, do not tighten the nuts and bolts until the 4 wheel alignment angles are adjusted. Tightening torque: 175 Nm

Installation

1. To install, perform the removal procedure in reverse order.

2. Adjust the wheel alignment angles.

The publication was copied from a web resource: LRman.ru