Removing
1. Raise and support the vehicle.
WARNING: Place secure stands under the vehicle.
2. Remove the wheel. Refer to procedure: Wheel and tire (204-04 Wheels and tires, Removal and installation).
3.
4.
Installation
1. Install the trailing arm.
2. Install the nuts, bolts and washers securing the trailing arm to the body and to the hub, but do not tighten at this stage.
3. Support the vehicle by placing a jack under the rear hub.
CAUTION: Nuts and bolts must be tightened when the weight of the vehicle is supported by the suspension.
4. Tighten nuts and bolts. Tightening torque: 270 Nm
5. Install the wheel. Refer to procedure: Wheel and tire (204-04 Wheels and tires, Removal and installation).
6. Check rear wheel alignment and adjust if necessary.
Comments on this article