Brake pads and linings (Freelander 2)
Install brake pads specified by the manufacturer on the vehicle. When replacing brake pads and linings, all brake pads and linings located on the same axle must be replaced.
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Previous articles
Current article
Brake pads and linings
Next articles
Working fluid of the brake system and clutch drive
Chemical materials
Anti-corrosion materials
Dust
Electrical equipment
Exhaust smoke
Fiber insulation
Fire
First aid
Technical rubbers
Foam — Polyurethane
Fuel
Gas cylinders
Service station tools and equipment
High pressure testing equipment
Using a jack
Liquid and grease lubricants
Environmental Precautions
Recycling
Noise
Solder
Solvents
Suspended loads
Viton
Welding
Chemical materials
Anti-corrosion materials
Dust
Electrical equipment
Exhaust smoke
Fiber insulation
Fire
First aid
Technical rubbers
Foam — Polyurethane
Fuel
Gas cylinders
Service station tools and equipment
High pressure testing equipment
Using a jack
Liquid and grease lubricants
Environmental Precautions
Recycling
Noise
Solder
Solvents
Suspended loads
Viton
Welding
Similar articles from Land Rover repair manuals:
• Removal and installation of front brake pads Discovery 3 (2004-2009)
• Brake linings, discs and brake calipers Range Rover 3 (2001-2012)
• Brake pads, calipers and discs Defender 2007+ (2007-2016)
• Removal and installation of front brake pads Discovery 3 (2004-2009)
• Brake linings, discs and brake calipers Range Rover 3 (2001-2012)
• Brake pads, calipers and discs Defender 2007+ (2007-2016)
No comments yet
Comments on this article