Removing
NOTE: The front seat skid motor is supplied as part of the front seat lower frame assembly.
1. Remove the front seat. For more information refer to Front Seat (78.10.44/99)
2. Remove a lateral overlay of a pillow of a forward seat.
- Remove 2 Torx head screws.
- Release from 4 clips.
3. Release the front seat adjustment switch.
- Remove two screws.
- Release 2 clips.
4. Remove an overlay of the basis of a forward seat.
- Remove the screw.
- Release 2 clips.
5. Remove the front seat base. Remove 6 nuts.
6. Remove the front seat sled motor.
- Disconnect the electrical connector.
- Release the electrical connector.
- Loosen 8 nuts.
Installation
1. Install the front seat skid motor.
- Tighten nuts (tightening torque 25 Nm).
- Connect the electrical connector.
- Fasten the electrical connector.
3. Establish an overlay of the basis of a forward seat.
- Fasten with clips.
- Tighten the screw.
- Fasten with clips.
- Tighten the screws.
- Fasten with clips.
- Tighten the screws.
Comments on this article