Removing
1.
WARNING: It is forbidden to carry out work on a vehicle standing on only one jack. Always support the vehicle with jack stands.
Raise and support the vehicle.
2. Remove the wheel.
3. Remove the half shaft. For more information refer to Rear Axle (47.11.01)
4. Clamp the axle shaft in a vise.
5. Remove the CV joint boot clamps.
6. Slide the CV joint protective cover along the axle shaft to gain access to the hinge.
7. Having rested the drift in the inner part of the CV joint, remove the CV joint from the axle shaft. Remove the snap ring and discard it.
8. Remove a cover of the external hinge of constant angular speeds.
Installation
1. Clear the details.
2. Install the CV joint protective cover.
3. Install the outer CV joint.
- Install retaining ring.
- Install the CV joint on the axle shaft, install the retaining ring in the corresponding groove, put the CV joint on the axle shaft completely.
- Pull on the CV joint to make sure the retaining ring is fully seated.
4. Pack the supplied grease into the joint.
5. Put a protective cover on the CV joint. Fasten with new clamps.
6. Install the axle shaft. For more information refer to Rear Axle (47.11.01)
7. Install the wheel. Tighten wheel nuts (tightening torque 140 Nm).
Comments on this article