Contents: Working fluids and filling volumes ⇩ Filling volume ⇩ General technical characteristics ⇩ Tightening torque specifications ⇩
Working fluids and filling volumes
| Name | Specification |
| * Antifreeze | Havoline Extended Life Coolant (XLC) or any ethylene glycol-based antifreeze that is methanol-free and contains only corrosion inhibitors manufactured using organo-acid technology (Organic Acid Technology - OAT). |
| Antifreeze concentration - provides freeze protection down to -40°C (-40°F) | 50% |
| Specific gravity of coolant at 20°C (68°F) for freeze protection down to -40°C (-40°F) | 1,068 |
| Volume of antifreeze used at 50% concentration: | |
| Without rear interior heater and fuel-fired auxiliary heater | 4.7 l |
| With rear passenger compartment heater but without fuel-fired auxiliary heater | 6.0 l |
| Without rear heater in the car, but with additional heater running on fuel | 5.1 l |
| With rear interior heater and fuel-fired auxiliary heater | 6.5 l |
CAUTION: * Do not use other antifreezes with Havoline Extended Life Coolant (XLC).
Filling volume
| Name | Filling volume |
| Without rear interior heater and fuel-fired auxiliary heater | 9.4 l |
| With rear passenger compartment heater but without fuel-fired auxiliary heater | 12.15 l |
| Without rear interior heater, but with additional fuel-fired heater | 10.35 l |
| With rear interior heater and fuel-fired auxiliary heater | 13.1 l |
General technical characteristics
| Name | Specification |
| Cooling system type | Sealed system with thermostatic control and remote expansion tank |
| Radiator | Cross flow, with integrated transmission fluid cooler and charge air cooler |
| Expansion tank | Remote reservoir with bleed screw and low coolant level sensor |
| The pressure for which the lid is designed | 110 kPa (1.1 bar) |
| Thermostat: | |
| Temperature of opening start | 88°C |
| Full disclosure | 95°C |
| Cooling fan | Driven by the engine via an electronically controlled viscous coupling |
| Cooling fan diameter | 500 mm (19,6 in) |
| Direction of rotation | Clockwise when looking at the engine from the front |
| Coolant pump | Centrifugal vane pump with belt drive from the crankshaft |
Tightening torque specifications
| Name | Nm | lb-ft |
| Expansion tank mounting bolts | 10 | 7 |
| Panel covering access to the radiator | 10 | 7 |
| Coolant pump bolts | 10 | 7 |
| Coolant pump pulley mounting bolts | 25 | 18 |
| Radiator mounting bolts | 25 | 18 |
| Refrigerant condenser mounting bolts | 6 | 4 |
| Charge Air Cooler Outlet Hose Clamp | 10 | 7 |
| Charge Air Cooler Inlet Hose Clamp | 10 | 7 |
| Cooling fan mounting bolts to viscous coupling | 10 | 7 |
| * Cooling fan assembly | 65 | 48 |
* Note: Left hand thread
(The article is based on information from the website: LRMAN.RU)
Comments on this article