Filling
1. Prepare the coolant of the required concentration.
FILLING CAPACITIES, LIQUIDS AND OILS, Lubrication system.
2. Set the interior heating control to the maximum heating position.
3. Remove the screw (in the air bleed hole) from the heater outlet hose.
4. Remove the screw from the air bleed hole located in the cooling system pipe.
5. Slowly pour coolant into the expansion tank until a continuous stream of coolant comes out of the air bleed hole.
6. Insert the screw into the hole in the heater outlet hose and tighten it.
7. Insert the screw into the hole in the coolant pipe and tighten it.
8. Replace the expansion tank filler cap.
9. Start the engine and warm it up to operating temperature.
CAUTION: DO NOT turn on the air conditioning system.
10. Make sure that warm air is coming out of the heating system nozzles.
(The source of the article is located on the website: «LRman.ru»)
NOTE: The absence of warm air at the nozzle outlet may indicate the presence of an air lock in the heater radiator. If necessary, cool the engine, unscrew the expansion tank cap and repeat the cooling system bleeding procedure using the air bleed hole.
11. Turn off the engine and let it cool.
12. Make sure there are no leaks and add fluid to the tank up to the "MAX" mark.
Comments on this article