Dismantling
1. Disconnect the connector from the inertial switch.
2. Turn away a bolt of fastening of an arm of the inertial switch to a bulkhead panel.
3. Remove the inertial switch from the bulkhead.
4. Turn away 2 nuts of fastening of the inertial switch to an arm.
5. Remove the inertial switch from the bracket.
Installation
1. Mount the inertia switch on the bracket.
2. Fit 2 nuts securing the inertial switch to the bracket and tighten them to a torque of 2 Nm.
3. Install the inertial switch bracket on the bulkhead.
4. Screw in a bolt of fastening of an arm of the inertial switch to a bulkhead panel and tighten it.
5. Connect the connector to the inertial switch.
6. For arming the inertial circuit breaker (to bring into working condition) you have to click on the top.
Comments on this article