Radio receiver — removal and installation (Discovery 1)

1. Disconnect the battery.

2. Insert SMD 4091 strippers or similar wire staples into the radio receiver sockets.

3. Remove the radio and remove the pullers.

4. Disconnect the wiring connector and antenna.

See the source on the website www.lrman.ru

5. Remove the radio.

6. Installation is carried out in reverse order.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Konstantin Nazarov

Selector lever illumination lamp (automatic transmission)
Start inhibit switch/reverse lamp (automatic transmission)
Parking brake indicator switch
Selector lock (automatic transmission)
Setting up the remote control
Front door drive (central locking)
Exterior rearview mirrors
Rear («fifth») door drive

Current article

Radio receiver — removal and installation

Speakers in the doors
Low-frequency speakers and crossover in the rear door
Trailer wiring connector
Front window lift motor
Rear window lift motor
Decorative cap for the instrument cluster
Instrument cluster
Instrument cluster printed circuit board

Comments on this article

No comments yet

Discovery 3

Discovery 1