Removing
1. Disconnect the wire "masses" from the battery. For more information refer to Specification.
2. Remove the thermostat housing.
- Place a container to collect liquid.
- Disconnect the coolant hoses from the thermostat housing. Turn out 3 bolts.
- Remove and discard the O-ring.
3.
WARNING: Wear eye protection.
Remove the thermostat.
- Clamp the thermostat housing in a vise.
- Release and remove the thermostat.
Installation
1. Clean the contact surfaces of the cover and thermostat housing.
2. When installing, follow the removal procedure in reverse order.
- Install a new O-ring to the thermostat.
- Tighten the bolts (tightening torque 10 Nm).
Comments on this article