Removing
1. Disconnect the wire "masses" from the battery. For more information refer to Specification.
2. Remove the direct ignition coil. For more information, refer to Ignition Coil with Spark Plug (18.20.44)
3. Remove the remaining direct ignition coils.
4. Clean the area around the spark plugs.
5. Turn out spark plugs.
Installation
1. Screw in the spark plugs. Tighten spark plugs (tightening torque 25 Nm).
2. Install the direct ignition coil. For more information, refer to Ignition Coil with Spark Plug (18.20.44)
3. Install the rest of the direct ignition coils.
4. Connect the wire "masses" to the battery. For more information refer to Specification.
Comments on this article