Special tool
Adapter for key 303-1069 |
Removing
All cars
1. Disconnect the wire "masses" from the battery. For more information, refer to Specification
2.
WARNING: It is forbidden to carry out work on a vehicle standing on only one jack. Always support the vehicle with jack stands.
Raise and support the vehicle.
3. Remove the front drive shaft. For more information refer to Front Driveshaft - 2.7L Diesel (47.15.02)
4. Remove the rear drive shaft. For more information refer to Rear propshaft (47.15.03)
5. Remove a basic pillow of a transmission. Turn out 4 bolts.
6. Disconnect the 3 electrical connectors of the transfer case.
7. Disconnect the wiring harness from the transfer case.
- Turn out 3 bolts.
- Release the clamp.
8.
WARNING: Plug all open connections to avoid contamination of the system.
Disconnect the breather. Push in the retaining ring.
9. Loosen the fuel line support bracket.
- Release the fuel lines.
- Turn out two bolts.
10. Release the selector cable from the guide bracket.
All cars
11. Support the gearbox with a jack.
12.
CAUTION: Secure the assembly to the transmission jack.
Support the transfer case with a gearbox jack.
13. With assistance, remove the transfer case.
- Remove 8 bolts.
- Remove the sealing ring.
Comments on this article