Dismantling
1. Remove the starter.
SYSTEM OF STARTING THE ENGINE AND CHARGING THE BATTERY, REPAIR WORKS, Starter - engine K1.8.
2. Install flywheel stop LRT-12-145 through the starter opening and secure it with two bolts.
3. Turn away a bolt of fastening of a pulley to a cranked shaft and remove a washer.
4. Remove the pulley from the crankshaft.
Installation
1. Clean pulley and counter mating surface.
2. Install the crankshaft pulley onto the crankshaft drive gear, making sure that the notch on the pulley is aligned with the pinion on the gear.
3. Screw in the crankshaft pulley bolt with washer and tighten it to 205 Nm.
4. Turn away bolts of fastening of a latch of a flywheel LRT-12-145 and remove a latch.
5. Reinstall the starter.
SYSTEM OF STARTING THE ENGINE AND CHARGING THE BATTERY, REPAIR WORKS, Starter - engine K1.8.
Comments on this article