Contents: Dismantling ⇩ Installation ⇩
Dismantling
1. Disconnect the negative battery terminal.
2. Disconnect the connector from the purge solenoid valve.
3. Disconnect the hose with quick-release connector from the purge valve.
CAUTION: Always plug the fittings and holes to protect the system from dirt.
4. Loosen the clamp and disconnect the purge hose from the intake manifold.
5. Loosen the clamp and slide the purge valve off the bracket.
Installation
1. Install the purge valve on the bracket.
2. Connect the purge hose to the intake manifold and secure it with a clamp.
3. Connect the hose with quick-release connector to the purge valve.
4. Connect the connector to the purge solenoid valve of the adsorber.
5. Connect the negative battery terminal.
Comments on this article