Dismantling
1. Disconnect "negative" battery terminal.
2. Disconnect the connector from the canister purge solenoid valve.
3. Disconnect the hose from the canister purge solenoid valve.
4. Turn away a bolt of fastening of the valve of a purge to an inlet receiver.
5. Remove purge valve, discard seal.
Installation
1. Wipe down the purge valve and mating surface on the inlet receiver.
2. Install a new seal on the purge valve.
3. Install the purge valve to the inlet receiver and secure it with the bolt.
4. Connect the electrical connector and hose to the canister purge solenoid valve.
5. Attach "negative" battery terminal.
Comments on this article