Removing
1. Disconnect both wires from the battery. For more information refer to Specification.
2. Remove the hood latch panel. For more information refer to Hood Latch Panel (76.16.22)
3. Remove the radiator. For more information refer to Radiator (26.40.01)
4. Remove both front impact sensors. For more information refer to Front impact sensor (76.74.08)
5. Release the wiring harness from the cross member.
6. Remove the wing molding. For more information refer to Front Fender Trim (76.43.54)
7.
Item name | Description |
1 | 8 spot welds. |
2 | 8 spot welds. |
8. Additional information:
- Weld seam. For more information, refer to Body Repairs.
- Anti-corrosion protection. For more information, refer to Corrosion Protection.
- Tolerances. For more information, refer to Body and frame.
Installation
1. Installation is carried out in the reverse order to dismantling.
Comments on this article