Rear door window lifter and electric motor (Discovery 3)

Special tool

Door glass opening handle 501-114

Removal

NOTE: The door glass must be lowered approximately one third.

1. Remove the rear door trim panel. For more information, refer to Rear Door Trim Panel (76.34.04)

2. Remove the speaker.

• Disconnect the electrical connector.
• Remove 4 screws.

3. Carefully remove the outer glass seal. Remove the screw.



4.

NOTE: Secure the glass in this position with a wedge.

Using the special tool, release the clamp and lift the glass to the top of the door frame.



5. Remove the window lift motor and window lift assembly.

• Disconnect the electrical connector.
• Remove 4 bolts.
• Unscrew 2 nuts.
• Rotate the assembly 90 degrees clockwise and remove it through the back of the opening, top side first.

Installation

1. Install the window regulator motor and window regulator assembly.

• Tighten the bolts and nuts (tightening torque 10 Nm).
• Connect the electrical connector.

2. Secure the glass to the window regulator.

• Remove the wedge.
• Roll down the window.

3. Install the outer glass seal.

4. Install the speaker.

• Tighten the screws.
• Connect the electrical connector.

5. Install the rear door trim panel. For more information, refer to Rear Door Trim Panel (76.34.04)