Special tool
501-114 Release Lever, Door Glass |
NOTE: If possible, lower the window glass approximately one third of the way.
Removing
1. Disconnect a wire of weight from the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
2. Remove the rear door module. Refer to Procedure: Rear Door Module (RDM) (419-10 Multifunctional electronic modules, Removal and installation).
3. Carefully remove the outer glass seal.
4. Release the glass from the glass lift mechanism. Raise the glass and secure it to the top of the door frame. Special tool: 501-114
5. Attach the glass to the top of the frame.
6.
- Remove the electric motor in gathering with a window regulator.
- Rotate the assembly inside the door 90 degrees and first remove the top edge from the hole.
Installation
1. Establish the electric motor in gathering with a window regulator. Tighten nuts and bolts. Tightening torque: 10 Nm
2. Fix glass of a window of a door on a window regulator.
3. Install the outer seal and secure it with the Torx screw.
4. Install the rear door module. Refer to Procedure: Rear Door Module (RDM) (419-10 Multifunctional electronic modules, Removal and installation).
5. Connect a wire of weight to the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
Comments on this article