Special tool
501-114 Release Lever, Door Glass |
NOTE: If possible, lower the window glass approximately one third of the way.
Removing
1. Disconnect the battery ground wire. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
2. Remove the speaker from the front door. Refer to Procedure: Front Door Speaker (415-01 Infotainment system, Removal and installation).
3. Carefully remove the outer glass seal.
4. Release the glass from the glass lift mechanism. Raise the glass and secure it to the top of the door frame. Special tool: 501-114
5. Remove the glass guide.
6. Remove the front door control module.
7. Remove the electric motor in gathering with a window regulator.
Installation
1. Establish the electric motor in gathering with a window regulator. Tighten nuts and bolts. Tightening torque: 10 Nm
2. Install the door control module.
3. Install the insert and glass guide. Tighten the bolt. Tightening torque: 10 Nm
4. Fix glass of a window of a door on a window regulator.
5. Install the outer seal and secure it with the Torx screw.
6. Install the front door speaker. Refer to Procedure: Front Door Speaker (415-01 Infotainment system, Removal and installation).
7. Connect a wire of weight to the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
Comments on this article