Removing
All cars
1. Remove the front bumper trim. For more information refer to Front Bumper Cover (76.22.72)
Vehicles with dynamic suspension
2. Disconnect the front air suspension valve block from the bumper.
All cars
3. Remove the windshield washer reservoir. Turn out 2 bolts.
4. Remove the front bumper. Remove 8 bolts.
5.
NOTE: Do not proceed with further disassembly if the part is being removed only for access.
Remove the front bumper air intake.
Installation
All cars
1. Install the front bumper air intake.
2. Install the front bumper assembly. Tighten the bolts (tightening torque 25 Nm).
3. Attach the washer reservoir. Tighten 2 bolts (tightening torque 10 Nm).
Vehicles with dynamic suspension
4. Attach the front air suspension valve block to the bumper.
All cars
5. Establish an overlay of a forward bumper.
For more information refer to Front Bumper Cover (76.22.72)
Comments on this article