Roof hatch module (Discovery 3)

Removal

1. Remove the rear upper console.

• Carefully release the 9 clamps.
• Disconnect the two electrical connectors.

2. Remove the sunroof module.

• Slide the module to the left to release it from the bracket.
• Disconnect the two electrical connectors.

Installation

1. Install the sunroof module.

• Connect the electrical connectors.
• Fix the module to the bracket.

2. Install the rear upper console.

• Connect the electrical connectors.
• Carefully secure the clamps.

3. Use T4 to configure the new sunroof module.

4. If the battery is disconnected, the one-touch and anti-pinch functions will not be available. Close the sunroof panel and keep the switch pressed for another 20 seconds until the sunroof completes a full cycle. This will complete the sunroof calibration procedure and reset these functions.

(Information obtained from the website: www.LRman.ru)