Contents: Removal ⇩ Installation ⇩
Special tool
Ball joint puller (LRT-54-027) 205-754 | 
Device for dismantling/replacing axle shafts (LRT-60-030/1) 204-506/1 | 
Device for dismantling/replacing axle shafts (LRT-60-030/3) 204-506/3 |
Device for mounting half-shafts 204-506-01 | 
Holders - a device for dismantling/replacing axle shafts (LRT-60-030/5) 204-506/5 | 
Bridge seal removal tool (LRT-37-004/2) 308-005 |
Pulse extractor (LRT-99-004) 100-012 | 
Mounting tool/guide for axle shaft seal 308-626/2 | 
Device for mounting axle shaft seal 308-626/1 |
Removal
CAUTION: To avoid damage to the ball joint, do not store or install axle shafts in the fully folded position.
CAUTION: To avoid damage to the ball joint, do not allow the axle shaft to hang loose on one side.
CAUTION: AAR type roller joints (Angularly Adjusted Roller), mounted on the inside of some axle shafts, do not have an internal retaining mechanism and can therefore become separated.
1.
CAUTION: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands.
Raise and support the vehicle.
2. Remove the left half shaft. For more information, refer to Front Left Drive Shaft (47.10.01)
3. Using special tools, remove the axle shaft seal and discard it.
Installation
1. Using the special tools, install the new axle shaft seal. Do not open the axle shaft seal guard until the axle shaft is fully seated.
Original version of the article on the website LRMAN.RU
2. Install the left half shaft. For more information, refer to Front Left Drive Shaft (47.10.01)
Comments on this article