| Threaded connection | In the SI system | In Pound Feet |
| Connecting the pipeline to the ABS electronic control unit | 17 Nm | 12 ft·lbs |
| Screws for securing the ABS modulator to the support bracket | 9 Nm | 7 ft·lbs |
| Fastening the ABS modulator bracket to the inner wing | ||
| - Nuts | 13 Nm | 10 ft·lbs |
| - Bolts | 8 Nm | 6 ft·lbs |
| Bleed nipple - front calipers | 10 Nm | 7.5 ft·lbs |
| Nuts securing the vacuum booster to the engine compartment bulkhead | 22 Nm | 16 ft·lbs |
| Exhaust Gas Recirculation (EGR) Heat Exchanger to Support Screws | 25 Nm | 18 ft·lbs |
| EGR Pipe Bracket to Engine Mounting Eye Bolts | 25 Nm | 18 ft·lbs |
| Screw securing the pipeline to the front caliper | 28 Nm | 21 ft·lbs |
| Front Caliper Guide Bolts | 27 Nm | 20 ft·lbs |
| Front Caliper Mounting Screws | 100 Nm | 74 ft·lbs |
| Front brake shield to hub assembly mounting screw | 8.5 Nm | 6.3 ft·lbs |
| Brake disc mounting screws to hub flange | 5 Nm | 3.7 ft·lbs |
| Screw for fastening the fuel rail to the bracket | 10 Nm | 7.5 ft·lbs |
| Screws for fixing the parking brake cable to the body and subframe | 22 Nm | 16 ft·lbs |
| Parking brake cable pressure plate screws | 22 Nm | 16 ft·lbs |
| Screws securing the parking brake lever assembly to the body | 22 Nm | 16 ft·lbs |
| Downhill Descent Control (HDC) Switch Screw | 5 Nm | 3.5 ft·lbs |
| Nuts securing the master cylinder to the vacuum booster | 25 Nm | 18 ft·lbs |
| Power steering fluid heat exchanger pipe mounting screws | 10 Nm | 7.5 ft·lbs |
| Nuts for the nipples of the primary and secondary lines of the brake system | 17 Nm | 12 ft·lbs |
| Rear brake pipe nipple nut | 17 Nm | 12 ft·lbs |
| Rear brake cylinder to brake shield mounting screws | 8 Nm | 6 ft·lbs |
| Torx screw for securing brake fluid reservoir to master cylinder | 8 Nm | 6 ft·lbs |
| Torx screw for securing brake fluid reservoir to brake master cylinder (left hand drive vehicle) | 6 Nm | 4.5 ft·lbs |
| Wheel mounting nuts | 115 Nm | 85 ft·lbs |
| Screw for fastening the turbocharger heat exchanger pipe to the bracket | 10 Nm | 7.5 ft·lbs |
| Screw for fastening the turbocharger pipeline to the cooling system line | 25 Nm | 18 ft·lbs |
| Vacuum pump mounting screws¹ | 22 Nm | 16 ft·lbs |
| Nut securing the vacuum reservoir to the support bracket | 10 Nm | 7.5 ft·lbs |
1 Use NEW screws.
Comments on this article