| Threaded connection | In the SI system | In Pound Feet |
| Generator screws | 45 Nm | 33 ft·lbs |
| Generator bracket mounting screws | 25 Nm | 18 ft·lbs |
| Ignition Coil Cover Screws | 10 Nm | 7.5 ft·lbs |
| Screws securing the heat shield to the exhaust manifold | 10 Nm | 7.5 ft·lbs |
| Nuts securing the heat shield to the exhaust manifold | 25 Nm | 18 ft·lbs |
| Nuts for fastening the front pipe of the exhaust system to the intermediate pipe | 60 Nm | 44 ft·lbs |
| Nuts securing the front pipe to the exhaust manifold | 60 Nm | 44 ft·lbs |
| Exhaust manifold to cylinder head mounting nuts t | 45 Nm | 33 ft·lbs |
| Screws securing the exhaust manifold heat shield to the front exhaust pipe | 9 Nm | 7 ft·lbs |
| Heated Oxygen Sensor (HO2S) | 55 Nm | 41 ft·lbs |
| Fastening the heat reflector shield to the generator bracket | ||
| - Nuts | 25 Nm | 18 ft·lbs |
| - Bolts | 10 Nm | 7.5 ft·lbs |
| Exhaust manifold to cylinder head mounting nuts * | 17 Nm | 12.5 ft·lbs |
| Nuts for the flange connecting the middle and rear pipes | 60 Nm | 44 ft·lbs |
| Ignition coil screws right side | 10 Nm | 7.5 ft·lbs |
| Rear pipe clamp nut | 55 Nm | 41 ft·lbs |
* Tighten sequentially.
The original was published on the portal (www.lrman.ru)
Comments on this article