| Threaded connection | In the SI system | In Pound Feet |
| Screws securing the air filter to the battery platform | 9 Nm | 7 ft·lbs |
| Bolts and nuts for fastening the filler neck to the body | 9 Nm | 7 ft·lbs |
| Locking ring for fastening the fuel pump unit and the pipe to the tank | 35 Nm | 26 ft·lbs |
| Fuel rail to intake manifold mounting screws | 8 Nm | 6 ft·lbs |
| Fuel tank to body mounting screws | 40 Nm | 29 ft·lbs |
| Heated Oxygen (HO ₂ S) Sensor | 40 Nm | 29 ft·lbs |
| Bolts and nuts securing ignition coils to left intake manifold - KV6 engine up to 2003 model year | 9 Nm | 7 ft·lbs |
| Forced idle switch (engine braking) | 2 Nm | 1.5 ft·lbs |
| Allen screws for mounting the Intake Air Control Valve (IACV) to the throttle body | 6 Nm | 4.5 ft·lbs |
| Subframe to body mounting screws | 190 Nm | 140 ft·lbs |
| Throttle body to intake manifold mounting screws * (K1.8) | ||
| - 1st reception | 4 Nm | 3 ft·lbs |
| - 2nd reception | 9 Nm | 7 ft·lbs |
| Torx screws for mounting the throttle body to the intake manifold chamber (KV6 engine) | 8 Nm | 6 ft·lbs |
| Torx screws for securing throttle actuator bracket to throttle body (vehicles with cruise control only) | 9 Nm | 7 ft·lbs |
| Torx screws for mounting the throttle position sensor to the housing | 1.5 Nm | 1.1 ft·lbs |
| Variable Geometry Intake Manifold (VIS) to Intake Manifold Chamber Fastening Screws (KV6 Engine Only) | 8 Nm | 6 ft·lbs |
* Tighten in sequence according to the recommendations in the Repair section.
The article is based on data from the website lrman.ru
Comments on this article