Rear Intake Camshaft Oil Seal (Freelander 1)

Dismantling

1. Disconnect the negative battery terminal.

2. Remove the air cleaning filter.

FUEL SUPPLY SYSTEM OF GASOLINE ENGINE, ADJUSTMENTS, Air cleaning filter, engine K1.8.

3. Lay out a rag to collect any leaking oil.



4. Release the camshaft position sensor harness connector from the bracket and disconnect the connector.



5. Unscrew the 2 bolts securing the oil seal cover to the cylinder head and move the cover to the side.



6. Remove the camshaft oil seal using the LRT-12-147 puller and the LRT-12-129 bolt.



7. Discard the camshaft oil seal.

Installation

1. Wash the oil seal seat and camshaft.



2. Check that the protective boot LRT-12-203 for installing oil seals is clean. Install the boot on the camshaft.

3. Install the oil seal using the LRT-12-148A tool.

NOTE: Rear oil seals are red in color.

CAUTION: Seals must be installed dry. Do not use the LRT-12-148 tool.

4. Wipe the camshaft oil seal cover and the mating surface.

5. Install the oil seal cover, screw in the bolts and tighten them to a torque of 6 Nm.

6. Connect the camshaft position sensor connector and secure it to the bracket.

7. Replace the air cleaning filter.

FUEL SUPPLY SYSTEM OF GASOLINE ENGINE, ADJUSTMENTS, Air cleaning filter, engine K1.8.

8. Connect the negative battery terminal.

9. Add oil to the engine.

MAINTENANCE, Engine oil and oil filter - K1.8.

The article is based on data from the website (LRman.ru)