Transmission oil pan (Freelander 2)

Removal

1. Raise and support the vehicle.

WARNING: Ensure that the vehicle is supported securely.

2. Drain the transmission fluid. Refer to procedure: Draining and Filling Transmission Fluid - 3.2L NA - I6 (307-01 Automatic/Transaxle Transmission, General Procedures).

3. Remove the front subframe assembly. Refer to procedure: Front Subframe (502-00 Uni-Body, Subframe and Mounting System, Removal and Installation).

4.

CAUTION: Be prepared to collect any leaking oil.

5. Remove the gasket.

Installation

1. For sealant specification information, refer to the specifications section. Refer to procedure: Specifications (307-01 Automatic/Transaxle Transaxle, Specifications).

2. Apply a 3mm bead of sealant to the area shown.



3. Install the transmission fluid housing and tighten the bolts in a crisscross pattern. Tightening torque: 14 Nm



4. Install the front subframe. Refer to procedure: Front Subframe (502-00 Uni-Body, Subframe and Fastening System, Removal and Installation).

(The article is based on data from the website: www.LRman.ru)

5. Fill the transmission with transmission fluid. Refer to procedure: Draining and Filling Transmission Fluid - 3.2L NA - I6 (307-01 Automatic/Transaxle Transmission, General Procedures).