Throttle body (Freelander 2)

Removal

1. Remove the cover and disconnect the ground cable from the battery. Refer to procedure: Specifications (414-00 Charging System - General Information, Specifications).

2. Remove the engine cover. Refer to procedure: Engine Cover - 2.2L Duratorq - Td4 (501-05 Interior Trim, Removal and Installation).

3. Remove the manifold absolute pressure (MAP) sensor. Refer to procedure: Manifold Absolute Pressure (MAP) Sensor (303-14B Electronic Controls - 2.2L Duratorq - Td4, Removal and Installation).





6.

CAUTION: Plug all openings.

7.

The seal should only be reused if it is not damaged. Plug all openings.

8.

CAUTION: The seal should only be reused if it is not damaged.

NOTE: Do not continue disassembly if the component is removed only for access.

Installation

1. Install the air temperature sensor.

CAUTION: Clean mating surfaces of any foreign material.

2. Install the throttle body and tighten the screws evenly. Tightening torque: 9 Nm

CAUTION: Clean mating surfaces of any foreign material.

3. Connect the inlet hose and secure it with a clamp.

CAUTION: Clean mating surfaces of any foreign material.

4. Connect the electrical connectors.

5. Secure the upper coolant hose.

6. Install the MAP sensor. Refer to procedure: Manifold Absolute Pressure (MAP) Sensor (303-14B Electronic Controls - 2.2L Duratorq - Td4, Removal and Installation).



7. Install the engine cover. Refer to procedure: Engine Cover - 2.2L Duratorq - Td4 (501-05 Interior Trim, Removal and Installation).

8. Connect the ground cable to the battery and install the cover. Refer to the procedure: Specifications (414-00 Charging System - General Information, Specifications).