Anti-roll bar (Discovery 1)

Removal

1. Mark the relative positions of the stabilizer and rubber bushings.

2. Unscrew the rubber bushing bracket fasteners.

3. Unscrew the ball joint fasteners to the stabilizer, remove the stabilizer.

Installation

4. Place new bushings on the stabilizer. The marks on the bushings should point towards the bridge.

5. Hang the stabilizer on the rubber bushing brackets. Adjust the position of the stabilizer according to the marks.

6. Tighten the tie rod ball joint fasteners to 68 Nm.

7. Tighten the rubber bushing bracket fasteners to a torque of 30 Nm.