2. Remove the cotter pin and loosen the castle nut a few turns.
3. Using puller 18G1063A, remove the ball joint from the rod.
1 - stabilizer, 2 - rubber bushing, 3 - bushing bracket, 4 - bolt, nut and washer, 5 - nut and washer, 6 - tie rod with ball joints, 7 - bolt and washer, 8 - castle nut and cotter pin.
(The original source of the article is the website LRMAN.ru)
4. Unscrew the castle nut completely and remove the ball joint
5. Installation is carried out in reverse order. Tightening torque of the crown nut is 40 Nm.
Comments on this article