Front seat (Discovery 3)

Removal

CAUTION: Before performing any work on the SRS system, read the relevant information carefully.

CAUTION: Always disconnect the battery before working on the SRS system. Disconnect the ground cable first. Never connect the battery with the polarity reversed.

1. Set the SRS system to fail-safe mode. For more information, refer to Standard Workshop Techniques

2.

NOTE: Torx head bolts can be reused.

Release the front seat fastening.

• Remove the bolt covers.
• Remove 5 Torx head bolts.

3. Release the lower seat belt anchor from the seat.

• Remove the bolt cover.
• Disconnect the electrical connector on the passenger side.
• Remove and discard the Torx head bolt.

4. With assistance, remove the front seat.

• Install panel protection.
• Remove the bolt.
• Disconnect the two electrical connectors.
• Release the 2 wiring harness clips.

Installation

1. Install the front seat with assistance.

• Connect the electrical connectors.
• Secure the wiring harness clamps.

2. Attach the lower seat belt anchor to the seat.

• Tighten the new Torx head bolt (tightening torque 40 Nm).
• Connect the electrical connector on the passenger side.
• Install the bolt cover.

3. Secure the front seat.

• Tighten the Torx head bolts (tightening torque 40 Nm).
• Install the bolt covers.

4. Connect the ground wire to the battery.

(The article is based on data from the website: LRman.ru)