Contents: Removal ⇩ Installation ⇩
Removal
NOTE: If the parking brake shoes or brake discs have not been removed to gain access to other components, the bedding procedure DOES NOT NEED to be performed.
1.
CAUTION: Do not turn on the ignition when the parking brake is in service mode, as this will disengage the parking brake.
Set the parking brake to service mode.
- Turn the ignition key to position II.
- Press and hold the foot brake.
- Set the parking brake switch to the RELEASE position and hold it in this position.
- Turn the ignition key to position 0 and remove it from the ignition switch.
- Release the foot brake.
- Release the parking brake switch.
2. Isolate the parking brake electrical circuit. Remove fuse 8 from the battery junction box.
3.
CAUTION: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands.
Raise and support the vehicle.
4. Remove the wheel.
5. Remove the brake caliper support bracket. For more information, refer to Brake Caliper Support Plate (70.55.29)
6. Release the parking brake shoe adjuster.
- Remove the plug from the hole in the brake disc.
- Using a suitable tool, rotate the brake shoe slack adjuster to release it.
- Install the access plug.
7. Remove the brake disc. Remove the Torx head screw.
Installation
1. Make sure the contact surfaces of the brake disc and wheel hub are clean.
2. Install the brake disc. Tighten the Torx head screw. (tightening torque 35 Nm).
3. Install the brake caliper support bracket. For more information, refer to Brake Caliper Support Plate (70.55.29)
4. Adjust the parking brake. For more information, refer to Adjusting the Parking Brake Shoes and Linings (70.40.11)
5. Install fuse 8 in the battery junction box.
6. Install the wheel. Tighten the wheel nuts. (tightening torque 140 Nm).
The text of the article was taken from the website: www.LRman.ru
Comments on this article